Warranty And Liability - Ega Master 79612 Manual De Instrucciones

• lubricating grease and oil,
• hydraulic fluid,
• coolant,
• solvent containing cleaning agents must not leak into the ground or reach the
sewage system.
These materials must be stored, transported, contained and disposed of in
suitable containers!
The following table shows possible problems and their causes:
Problem
a Machine does not start
b Machine is rotating too slowly
c Machine makes strong noise
d
Other trouble
If necessary, we ask you to send the machine to the supplier.
Unless otherwise specified, our "General Sales Terms" apply.
Warranty and liability claims in regards to persons or equipment damages are invalid, if one or
several of the following causes apply:
• Improper use of the machine.
• Improper assembly, startup, operation or maintenance of the machine.
• Operation of the machine with defect safety devices or improperly fixed or non-functioning safety
and protection devices.
• Non-observance of the instructions in the operating instruction booklet concerning transport,
storage, assembly, startup, operation, maintenance and setting up of the machine.
• Independent structural alterations or settings on the machine beyond the intended purpose
• Inadequate supervision of wear parts.
• Improperly carried out repairs, inspections or maintenance
• Catastrophic cases because of a war, acts of god or other reasons which are beyond our control.
TROUBLESHOOTING
Cause
not connected to pneumatic
supply
Too little operating pressure
Hose diameter too small Too
little volume flow
-
-

WARRANTY AND LIABILITY

Remedy
Connecting and opening of
the pneumatic line
Increase operating pressure
Choose larger hose diameter
Increase volume flow
Contact authorized expert
company
Contact authorized expert
company
37