Spare Parts List - Ega Master 79612 Manual De Instrucciones

Disassembly
Disassembly and re-assembly should only be performed with assistance of the sectional drawing.
Loosen screws item 22 and remove motor housing cover item 20 with sealing item 19 for changing
the vanes. Pull off the end plate item 17 and rotor item 14. Take the vanes item 16 out of the rotor slots.
The slots have to be cleaned from oil and resin residues before installing new vanes. The assembly of
the rotor is done after having cleaned the running surface of the end plates and the cylinder bushing.
The vanes are considered to be worn, when their width is less than 19.5 mm.
Complete disassembly
Loosen screws item 58, pull off impact mechanism housing item 51 with complete impact
mechanism and continue disassembling. Remove centring ring item 37. Remove motor housing cover
item 20 and sealing item 19 after loosening the screws item 22. Take inner motor parts like end plates
item 10 and 17, rotor item 14 and cylinder bushing item 12 with locking pin item 13 out of the motor
housing item 1. Pull the vanes item 16 out of the rotor slots. Press the locking bolt item 15 out of the
rotor drillings. Remove the nipple with screen item 35 from the air connection piece item 4, remove air
connection piece, Assy., item 4 and take out valve pin item 28, screw nipple item 36 out of handle part.
Remove tension sleeves item 7 and 26 and take out valve trigger item 25 and pull out reverse valve
item 5. Pull out pin item 9 and pressure spring item 8.
Re-assembly
The re-assembly is basically done in the reverse order than the disassembly. Wear and tear parts-
especially the vanes item 16 – should be replaced in time. They are considered to be worn, when the
width is less than 19.5 mm. If the rotor or the cylinder bushing has been replaced, respectively the
plane surface has been finish grinded, the end play between the rotor and the end plates item 10 and
17 has to be checked. The end play should be 0.05 mm on each side (the cylinder bushing must be 0.1
mm longer than the rotor measurement). The fixing screws have to be installed with a screw locking, e.
g. Loctite 243.
After re-assembly the function and performance of the impact wrench have to be checked.
For this, refer to the technical data of the operation and maintenance instruction.
Spare Parts
Only original spare parts may be used. There is no warranty for damages and liability is disclaimed,
if non-original spare parts and accessories are used.
38

SPARE PARTS LIST

REPAIR
Vane
Installation dimension 21.6
Replace <19.5