Assembly - AL-KO ATC-DISPLAY Manual Del Usuario

Assembly

ASSEMBLY
We recommend having all installation work carried out only by compe-
tent specialist workshops or our AL-KO Service Centres.
CAUTION!
Danger due to malfunction!
ATC must not be connected to the power supply during installation.
Before installing the ATC Display, disconnect the 13-pin plug from the
towing vehicle!
Note the AL-KO Trailer Control self-test.
Before setting off, compare the LEDs on the ATC Display with the LEDs on
the ATC Transmitter.
Before setting off, check that all LEDs are operational.
Check the LED
1. Insert the 13-pin trailer cable on the towing vehicle (7).
2. The ATC begins a self-test
The LED illuminates red for around 3 seconds, then the LED switches
to green. The ATC is ready!
Installing the ATC transmitter
1. Remove the towbar cover (1).
2. Remove the retaining plate and loosen the nut on the LED (2).
3. Carefully separate the shrink hose with the knife and remove it (3).
4. Pull the push-on contacts off the LED and dispose of the LED (3).
If the LED is soldered:
1.
2.
* Blade terminal 2.8x0.8-1.00
5. Push the large shrink hose over both cables and pull it towards the rear (4).
6. Push a small shrink hose over each of the cables (5).
7. Connect the push-on contacts (transmitter and ATC) (6).
Pay attention to the colours!
693 762_c
cut off the LED.
Crimp a blade terminal* onto each cable of the ATC.
is not supplied.
2
15