Elba EGV 13 Instrucciones Para El Uso página 25

5
5
IMPORTANT: Installation must be carried out according to
the manufacturer's instructions. Incorrect installation may
cause harm and damage to people, animals or property,
for which the manufacturer accepts no responsibility.
ELECTRICAL PART
The appliance must be connected to the mains by a competent
electrician and according to the regulations in force.
The appliance must be connected to the mains checking first
of all that the voltage corresponds to the value given on the rat-
ing plate and that the section of the electrical cables can take
the load indicated on the rating plate.
If the hob is supplied without plug, fit a standard plug which is
suitable for the power absorbed by the appliance and in con-
formity with the local rules in force.
The plug must be put into a socket connected to the earth sys-
tem in compliance with safety rules.
For the United Kingdom:
As the colours of the wire of the supply cable of this appliance
may not correspond with the colours which identify the
terminals of your plug, proceed as follows:
– the yellow/green wire must be connected to the plug
terminal marked with the letter E or with the earth symbol
or coloured green or yellow/green;
– the blue wire must be connected to the terminal marked
with the letter N or coloured black;
– the brown wire must be connected to the terminal marked
with the letter L or coloured red;
The connection can be made directly to the mains by putting
an all-pole switch with minimum opening between the
contacts of 3 mm between the appliance and the mains.
The supply cable must not touch hot parts and must be so
positioned that it does not exceed the temperature of 75°C
at any point.
When the appliance is installed the switch or socket must
always be accessible.
The appliance must have its own supply; any other appliances
installed near it must be supplied separately.
Before carrying out any work on the electrical section
of the appliance, it must be disconnected from the
mains.
ELECTRICAL SECTION
Connection to a good earth wiring system is absolutely
essential.
The manufacturer accepts no responsibility for any
inconvenience caused by failure to comply with this rule.
– N.B. For connection to the mains do not use adapters
– If the hob surface is cracked disconnect the appliance from
If the installation requires modifications to the domestic electrical
system or if the socket and the appliance plug are not compatible,
contact a professional electrician.
He must, in particular, also make sure that the section of the
socket cables is suitable for the power absorbed by the appliance.
reductions or shunts because these can cause overheat-
ing or burning.
the mains.
25