Operational Cautions - Metabo HPT M 18DYA Manual De Instrucciones

CAUTION
● Do not look directly into the light from the LED
lamp. Continuous and direct exposure to the
light from the LED lamp can injure your eyes.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
Safeguard Function
Overload Protection
Temperature Protection
5. Cutting Operation
CAUTION
Do not press the lock button while the motor is
rotating. Also, do not switch the tool on while pressing
the lock button.
Doing so may damage the lock button and/or shaft as
well as result in injury.
NOTE
○ Moving the tool forward fast may cause a poor quality
of cut, or damage to the bit or motor.
○ Abnormalities and overloads will trigger the overload
protector, and stop operation. Remove the load
immediately, and turn the power off , then on. The
rotation speed should return to normal.
(1) Keep the bit separated from the workpieces and hold
the body fi rmly before switch is turned on.
(2) The bit rotates clockwise (arrow direction indicated
on the base ass'y). To obtain maximum cutting
eff ectiveness, feed the tool in conformance with the
feed directions shown in Fig. 14.
Table 5
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
4. LED light warning signals
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
activate during operation, the LED light will blink as
described in Table 5. When any of the safeguard
functions are triggered, immediately remove your
fi nger from the switch and follow the instructions
described under corrective action.
Remove the cause of the overloading.
Allow the tool and battery to thoroughly
cool.
Outer peripheral cutting
(Counterclockwise)
Inner peripheral cutting
(Clockwise)

OPERATIONAL CAUTIONS

Resting the unit after continuous work
After use for continuous work, rest the unit for 15 minutes
or so when replacing the battery. The temperature of
the motor, switch, etc., will rise if the work is started
again immediately after battery replacement, eventually
resulting in burnout.
English
Corrective Action
Work piece
Rotation of bit
Tool feed
Fig. 14
15