Starting Procedure - Stihl HL 100 Manual De Instrucciones

Symbol on slide control
h (7) – stop symbol and arrow – to stop
the engine, push the slide control in
direction of the arrow on the stop symbol
(h) to STOP-O.

Starting Procedure

: Hold down the throttle trigger
interlock and squeeze the throttle
trigger.
: While holding both levers in this
position, move slide control to
START and hold it there.
: Now release the throttle trigger,
slide control and throttle trigger
interlock in that order. This is the
starting throttle position.
HL 100
9
8
: Set the choke knob (8):
For cold start to g
For warm start to e
Also use this setting if engine has
been running but is still cold.
: Press fuel pump bulb (9) at least five
times – even if the bulb is filled with
fuel.
English / USA
: Place the unit on the ground: It must
rest securely on the engine support
and the gearbox.
: On units with an adjustable cutter
bar and defined transport positon:
Set the cutter bar to the straight (0°)
position.
: Remove the blade scabbard. Check
that the cutting blades are not
touching the ground or any other
obstacles. If necessary, rest the
gearbox on a raised support (e.g. a
mound, brick or something similar).
: Make sure you have a firm footing:
Press the unit firmly against the
ground with your left hand. Your
thumb should be under the fan
housing.
Do not stand or kneel on the
drive tube. This will bend the tube
and result in permanent damage to
the drive tube.
23