Replacing Starter Rope And Rewind Spring - Stihl HL 100 Manual De Instrucciones

English / USA
Lubricate the angle drive with STIHL
gear lubricant for brushcutters – see
"Special Accessories".
The position of the filler plug may be
different on some models.
About every 25 hours of operation
: Unscrew the filler plug (2).
: If no grease can be seen on the
inside of the filler plug, screw the
tube of grease into the filler hole.
: Squeeze up to 5 g (1/5 oz) grease
into the gearbox.
Do not not completely fill the
gearbox with grease.
: Refit the filler plug and tighten it
down firmly.
30
Replacing Starter Rope
and Rewind Spring
1
2
1
Replacing the starter rope
: Move slide control in direction of
c – arrow to STOP-O.
: Take out the screws (1).
: Lift the starter cover (2) off the
housing.
1
: Remove the spring clip (3).
: Remove the rope rotor with
washer (4) and pawl (5).
3
4
5
HL 100