Storage And Transport; General Instructions; Mounting Instructions - Vega VEGASWING S 52 Instrucción De Servicio

2.3 Storage and transport

Packaging
Your instrument was protected by packaging
during transport. Its capacity to handle normal
loads during transport is assured by a test
according to DIN EN 24180.
The packaging consists of environment-friendly,
recyclable cardboard. In addition, the sensor is
provided with a protective cover of cardboard.
Dispose of the packaging material via specialised
recycling companies.
3 Mounting

3.1 General instructions

Switching point
In general, VEGASWING S 52 can be mounted in
any position. The instrument must be mounted in
such a way that the tuning fork is at the height of
the requested switching point.
2
1
3
Fig. 11: Vertical mounting
1 Switching point approx. 13 mm in water
2 Switching point with lower density
3 Switching point with higher density
VEGASWING S 52
1
2
Fig. 12: Horizontal installation
1 Switching point
2 Switching point (recommended mounting position,
particularly for adhesive products)
Moisture
Fig. 13: Measures against moisture penetration
Handling
Do not hold VEGASWING S 52 on the tuning fork.
Bending the vibrating element will destroy the
instrument.

3.2 Mounting instructions

Welded socket
VEGASWING S 52 has a defined thread runout
point. This means that every VEGASWING S 52 is
in the same position after being screwed in.
Remove therefore the supplied flat seal from the
thread of VEGASWING S 52. This flat seal is not
required when using a welded socket with front-
flush O-ring.
The welded socket has a marking (notch). For
horizontal mounting, weld the socket with the notch
facing upward or downward; in pipelines aligned
with the direction of flow.
Mounting
13