Connecting To Voltage Supply; Preparing The Connection; Wiring Plan; Indication Of The Switching Status - Vega VEGASWING S 52 Instrucción De Servicio

Connecting to voltage supply

Fig. 14: Marking on the welded socket
1 Marking
Adhesive products
In case of horizontal mounting in adhesive and
viscous products, the surfaces of the tuning fork
should be vertical. The position of the tuning fork is
indicated by a marking on the hexagon of
VEGASWING S 52. With this, you can check the
position of the tuning fork when screwing it in.
In case of horizontal mounting in adhesive and
viscous products, the tuning fork should protrude
into the vessel to avoid buildup on the tuning fork.
Flows
To minimise flow resistance caused by the tuning
fork, VEGASWING S 52 should be mounted in
such a way that the surfaces of the blades are
parallel to the product movement.
4 Connecting to voltage
supply

4.1 Preparing the connection

Note safety instructions
Generally note the following safety instructions:
Connect only in the complete absence of line
l
voltage

4.2 Wiring plan

M12x1 plug connection
This plug connection requires a complete confec-
tioned cable with plug.
14
1
Fig. 15: Wiring plan, transistor output with M12x1 plug connection
Valve plug DIN 43650
For this plug version, standard cable with round
wire cross-section can be used. Cable diameter
4.5 ... 7 mm, protection IP 65.
Fig. 16: Wiring plan, Transistor output with valve plug DIN 43650
Fig. 17: Wiring plan, contactless electronic switch with valve plug
DIN 43650
5 Setup

5.1 Indication of the switching status

The switching status of the electronics can be
checked via the signal lamp integrated in the upper
part of the housing.

5.2 Function test

VEGASWING S 52 has an integrated test switch
which can be activated magnetically. Proceed as
follows to test the instrument:
R
L
- +
1 2
3
R
L
L- L+ L-
PA PA
1 2
3
R
L
L1+ N- L1+
PE PE
R
L
+
-
1 2
3
R
L
L+
1 2
3
R
L
N-
VEGASWING S 52