Spraying Precautions; Moisture In Compressed Air - Campbell Hausfeld HL4330 Manual De Instrucciones

safety guidelines

SPRAYING PRECAUTIONS

16. Do not smoke when spraying paint, insecticides, or other flammable substances.
17. Use a face mask / respirator when spraying and spray in a well ventilated area to prevent health and fire
hazards.
18. Do not direct paint or other sprayed material at the compressor. Locate compressor as far away from the
spraying area as possible to minimize overspray accumulation on the compressor.
19. When spraying or cleaning with solvents or toxic chemicals, follow the instructions provided by the chemical
manufacturer.

MOISTURE IN COMPRESSED AIR

Moisture in compressed air will form into droplets as it comes from an air compressor pump. When humidity is
high or when a compressor is in continuous use for an extended period of time, this moisture will collect in the
tank. When using a paint spray or sandblast gun, this water will be carried from the tank through the hose, and
out of the gun as droplets mixed with the spray material.
IMPORTANT: This condensation will cause water spots in a paint job, especially when spraying other than
water based paints. If sandblasting, it will cause the sand to cake and clog the gun, rendering it ineffective.
A fi lter in the air line, located as near to the gun as possible, will help eliminate this moisture.
specifications
Specifi cations
HP
Tank capacity
Number of Cylinders
Air Delivery @ 90 psi
Voltage
Amps
Phase
Max pressure
Oil capacity
Tank outlet size
Length
Width
Height
Weight
Do not spray fl ammable materials in vicinity of open fl ame or near ignition sources including the
compressor unit.
SAVE THESE INSTRUCTIONS DO NOT DISCARD
HL4330
1.6
20 gallons
1
4.5 scfm
120 volts
14.5 amps
1
125 psi
8.18 oz
1/4 inch npt
19.3 inches
18.11 inches
43.32 inches
97 lbs
6