Cleaning And Disinfection - MSA F2 X-TREM Manual De Instrucciones

MSA recommends that this complete control is performed at least every two (2) years, more regularly
in case of intensive use (every year for instance), or each time the helmet has been exposed to very
severe conditions (mechanical impact, very high temperature, direct flame contact, contact with
pouring metal or chemicals). In cases where frequency of use is very low and none of the mentioned
exposures and damages are recorded, an inspection should be performed at least every 4 years. Local
regulations may apply.
WARNING!
In case of visible damage identified during the daily check (before or after use), such as impacts, signif-
icant scratches, coating removal on the shell or visors, melted parts, broken parts, torn straps or
paddings, missing components, non-operational moving parts (such as visors or ratchet), etc., the
helmet should be taken to the trained maintenance technician or an MSA approved maintenance
center for complete control processing.
8.1

Cleaning and Disinfection

Cleaning the Neck Curtains
Wool neck curtain:
• Cleaning at 30°C with a gentle detergent
Aluminized neck curtain:
• Cleaning at 30°C with water, using a sponge.
8.2 Transport
Store the googles inside the helmet (out of use position), the helmet can be stored in a MSA protective
bag (GA1043).
8.3 Discard
The helmet must be treated as ordinary industrial waste/non-hazardous waste according to local regu-
lations. For further information contact MSA.
F2 X-TREM
Maintenance and Cleaning
GB
9