On-Wall Installation - BKS B-55600-20-1-8 Manual De Instrucciones Y De Montaje

Installation and operating instructions
B-55600-20-1-8 | B-55600-20-4-8 | B-55600-23-1-8 | B-55600-23-4-8
Fingerprint scanner and code keypad
4.2
EN
58

On-wall installation

Fasten the on-wall housing. We recommend
an installation height of between 1.2 and 1.4 m
above finished floor level. You can use the
enclosed screws (3.5 x 25) and plugs for this.
„
„
„
„
„
„
„ Remove the terminal board by undoing the
two screws.
„ Push the terminal board into the groove
of the on-wall housing that has been pre-
pared for this.
„
Connect the supply line to the internal
unit accordingly at terminals 1 to 4.
„
Remove the back of the housing.
„ Note: the module will not fit into the on-
wall housing with the back of the housing
attached.
„ Fasten the supporting frame using the 4
enclosed screws (3.5 x 25).
07.2017 | XX | Designed in Germany