Operation Of Code Keypad - BKS B-55600-20-1-8 Manual De Instrucciones Y De Montaje

Installation and operating instructions
B-55600-20-1-8 | B-55600-20-4-8 | B-55600-23-1-8 | B-55600-23-4-8
Fingerprint scanner and code keypad
9.
Master code
User code
In the delivery condition all 3 LEDs (red/green/blue) light up continuously. A
remote control is not included in the scope of delivery as all entries can be
made at the code keypad itself.
NOTE
Certain master code or user code combinations are excluded for security
reasons. These are regular combinations of numbers such as 8888, 123456
or 4321, etc. The master code or user code can contain a combination of
4–6 digits.
For the initial master code (factory code) refer to page 50 of this manual.
NOTE
If an incorrect user code is entered 5 times in succession, the device swit-
ches to the blocking mode. This prevents unauthorised persons from gaining
access. If the device is in blocking mode, the red LED flashes to indicate this.
The blocking mode initially has a time limit. The blocking time extends up to
five times (blocking intervals: 1 minute, 5 minutes, 30 minutes, 1 hour,
permanently blocked after that) following each subsequent failed attempt.
If a valid user code is entered two times in succession, the blocking mode is
cancelled.
EN
88

Operation of code keypad

Door opening
* Start input or confirm
Administration code
Code for door opening
Each time a button is pressed, the green LED lights
up briefly to indicate this.
If the green LED does not light up once a button has
been pressed, repeat the input.
We always recommend to replace the factory code
by your own master code!
07.2017 | XX | Designed in Germany