Harbor Breeze BELLEVUE E-BE44ABZ5C Manual Del Usuario página 13

WIRING
1C. FAN AND LIGHT CONTROLLED BY
TWO WALL SWITCHES: If you intend to
control the fan and light with separate wall
switches, connect BLACK wire from fan to
BLACK wire from the independent wall switch
for the fan. Connect BLUE wire from fan to the
BLACK wire from the other independent wall
switch for the light. Connect WHITE wire from
fan to WHITE wire from ceiling. Connect all
GROUND (GREEN) wires together from fan
(on downrod (A) and mounting bracket (C)) to
BARE/GREEN wire from ceiling. (Fig. 1C)
NOTE: Black wire is hot power for fan. Blue wire
is hot power for light kit. White wire is common
for fan and light kit. Green or bare wire is ground.
Wrap electrical tape around each individual wire
2.
connector (CC) down to the wire as shown in Fig. 2.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of box
from the black and blue (if applicable) connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (CC) into outlet box.
Hardware Used
CC E3 Wire Connector
3. IMPORTANT: Using a full range dimmer switch
to control fan speed will cause a loud humming
noise from fan. To reduce the risk of fire or
electrical shock, do NOT use a full range
dimmer switch to control fan speed. (Fig. 3)
FAN AND LIGHT CONTROLLED BY TWO WALL
SWITCHES
1C
120 V Power
FROM
CEILING
BLUE
BLACK
FAN
GREEN
2
CC
x4
3
Dimmer
Switch
For illustrative purposes only--not
intended to cover all types of controls
13
BLACK (WALL SWITCH)
BLACK (WALL SWITCH FOR LIGHT)
WHITE
GROUND/GREEN (BARE)
WHITE
GREEN
WHITE
FROM FAN
CC
3
2
1
Speed
Switch
CC
CC