DeWalt DCW210 Manual De Instrucciones página 36

ENGlIsh
The rate at which the dust collection bag fills up will vary
with the type of material being sanded and the coarseness
of the sandpaper. For best results, empty the bag frequently.
When sanding painted surfaces, (see the following for
additional precautions when sanding paint) you may
find that the sandpaper loads up and clogs with paint. A
heat gun will work much better to remove paint before
sanding. FOLLOW ALL SAFETY INSTRUCTIONS IN HEAT GUN
INSTRUCTION MANUAL.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Replacing the Sanding Pad and the Belt
(Fig. F)
Your sander is equipped with a replaceable belt
is located between the pad
6
It is designed to control the pad speed while the unit is
off the work surface. The belt and the sanding pad
designed to be consumable parts and will occasionally need
to be replaced. The sanding pad needs replacement when
signs of wear become evident. Replacement of the belt is
necessary when the pad speed increases very dramatically
when the unit is lifted from the work surface. These parts are
available at extra cost from your local dealer or authorized
D WALT service center.
e
1. Holding the platen firmly, remove the four screws 13)
from the bottom of the pad.
2. Remove the pad .
6
3. Replace worn or damaged belt
around the shoulder screw
as shown in Figure F.
4. Reinstall pad (replace with new pad if necessary).
Replace the four screws
13
tighten screws.
34
which
11
and the sander body .
12
6 are
14 by wrapping it
15 and bearing retainer 16
. Be careful not to over-
Fig. F
Repairs
The charger and battery pack are not serviceable. There are
no serviceable parts inside the charger or battery pack.

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a D
service center or a D WALT authorized service center.
e
Always use identical replacement parts.
Accessories

WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
spECIFICaTIoNs
DCW210 20 V Máx*
* Maximum initial battery voltage (measured without a
workload) is 20 volts. Nominal voltage is 18.
13
6
14
10
15
11
12
WALT factory
e
WALT
e
8000–12000 opm