Two Piece-Shaft; Bevel Gear; Maintenance Schedule - Husqvarna 535LK Manual Del Usuario

2. Remove the air filter cover and remove the air filter.
3. Clean the air filter with warm soap water. Make sure
that the air filter is dry before you install it.
4. Replace the air filter if it is too dirty to fully clean it.
Always replace a damaged air filter.
5. Also clean the inner surface of the filter cover. Use
air or a brush.
6. Do a check of the rubber sealing surface. Replace
the filter on the rubber seal if it is damaged.
7. Make sure that the filter is dry before you assemble
it.

Bevel gear

The bevel gear is filled with the right quantity of grease
at the factory. But, before you use the product, make
sure that the bevel gear is 3/4 full with grease. Use
Husqvarna special grease.
Maintenance
Clean the external surface.
Make sure that the throttle trigger lock and the throttle works correctly from a
safety point of view.
Do a check of the stop switch to make sure that it works correctly.
Make sure that the cutting attachment does not rotate at idle speed.
Clean the air filter. Replace if necessary.
Examine the cutting attachment guard for damages and cracks. Replace the
guard if it has been exposed to impact or is cracked.
331 - 008 - 24.04.2020
The grease in the bevel gear does not need to be
changed unless repairs are carried out.

Two piece-shaft

Apply grease to the end of the drive shaft after each 30
hours of operation. There is a risk that the drive shaft
ends (splined coupling) on models with two-piece shafts
will seize if they are not lubricated regularly.

Maintenance schedule

The following is a list of the maintenance steps that must
be performed on the product. Most of the items are
Maintenance on page 15
described in
Note: The user must only carry out the maintenance and
service work described in this operator's manual. More
extensive work must be carried out by an authorized
service workshop.
Daily Weekly Monthly
X
X
X
X
X
X
17