To Disassemble The Cutting Attachment Guard And Trimmer Head; Operation - Husqvarna 535LK Manual Del Usuario

6. Put the locking pin (C) in the hole to lock the shaft.
7. Turn the trimmer head /plastic blades (H) in the
opposite direction from which the trimmer head/
plastic blades rotates.
H
To disassemble the cutting attachment guard
and trimmer head
1. Turn the trimmer head /plastic blades (H) in the
direction from which the trimmer head/plastic blades
rotates.
H
Fuel
This product has a two-stroke engine.
CAUTION: Incorrect type of fuel can result in
engine damage. Use a mixture of gasoline
and two-stroke oil.
Gasoline
CAUTION: Always use a quality gasoline/oil
mixture of at least 90 octane (RON). There
is a risk that use of lower octane grade
causes knocking. This gives rise to high
engine temperature, which can result in
serious engine damage.
CAUTION: If your product is equipped with a
catalytic converter use a good quality
331 - 008 - 24.04.2020
H
H

Operation

2. Pull the locking pin (C) out from the hole to unlock
the shaft.
3. Remove the drive disc (B) on the output shaft.
4. Loosen the bolt(L) from the cutting attachment
guard-fitting on the shaft.
A
5. Remove the cutting attachment guard (A).
unleaded gasoline/oil mixture. Leaded
gasoline will destroy the catalytic converter.
• Use low-emission gasoline, also know as alkylate
gasoline, if it is available.
• Ethanol blended fuel, E10 may be used (max 10%
ethanol blend). Using ethanol blends higher than
E10 will cause lean running condition which can
damage the engine.
• We recommend a higher octane rating when you do
work at continuous high speed.
B
C
A
11