To Start The Product; To Prepare The Product For Start; About The Surface - Husqvarna 535LK Manual Del Usuario

• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, trimmer guard and
trimmer head correctly attached and not damaged or
cracked. Replace if they are exposed to impact or
cracked.
WARNING: Do not use the product without a
guard or a guard that is defective.

To prepare the product for start

1. Press the air purge again and again until the fuel
starts to fill the bulb.
Note: It is not necessary to fully fill the bulb.
2. Move the choke control up into choke position.
331 - 008 - 24.04.2020
WARNING: The cutting attachment will
start to rotate immediately when you
start the engine with the choke.

To start the product

WARNING: Read the warning instructions in
the safety chapter before you start the
product (refer to
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
3. Hold the starter rope handle.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawl grip).
WARNING: Do not twist the starter rope
around your hand.
5. Pull the cord quickly and with power.
CAUTION: Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
6. Pull the starter rope again and again until the engine
starts.
7. Reset the choke when the engine fires.
8. Operate the throttle gradually when the engine
starts.
9. Make sure the engine runs smoothly.

About the surface

WARNING: Do not put parts of your body in
the grey marked area. If you touch the grey
marked area it can result in burns to the
skin. It can also cause electrical shock if the
spark plug cap has been damaged. Do not
use a product with a damaged spark plug
cap.
Safety on page 4 ).
13