User Maintenance; Care And Servicing Of Your Andis Clipper Blades; Correct Disposal Of This Product - Andis RBC Manual De Uso Y Cuidado

USER MAINTENANCE

Cleaning and user maintenance shall not be made by children without
supervision.

CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES

The internal mechanism of your clipper is permanently lubricated at the factory. Other than the
recommended maintenance described in this manual, no other maintenance is needed or should be
performed, except by an Andis Authorized Service Station. Depending upon use, the blade set of your
Andis clipper will deliver 6 months of service before it needs to be replaced.
1. To prevent injury, always replace broken or nicked blades.
2. Andis clippers operate at high speeds. For greater convenience,
purchase an additional blade set to substitute for a hot blade set.
Check often for blade heat, especially when the blade housing is
adjusted for close cutting. To cool, dip the hot BLADES ONLY into
Andis Blade Care Plus, or apply Andis Cool Care Plus. After using a
coolant, be sure to lubricate the blade with Andis Clipper Oil, as
spray coolants do not contain enough lubricant for extended clipping
(Diagram N).
3. To get the maximum run time from your lithium-ion battery, oil
clipper blades before, during, and after each use. Blades that leave
streaks or slow down may need oil. Place a few drops of oil on the
front and side of the cutter blades. Thoroughly wipe excess oil off
blades with a soft, dry cloth to prevent oil from dripping down into
the clipper housing.
4. Clean the blade using a small brush or toothbrush. Periodically, clean
blades by immersing the BLADES ONLY into a shallow pan of Andis
Clipper Oil, while the clipper is running. Excess hair and dirt that has
accumulated between the blades should release.
5. After cleaning, turn your clipper off and dry blades with a clean, dry
cloth and resume clipping. If after cleaning, blades will still not cut, a
few, fine pieces of hair may be trapped between the upper and lower
blades. Remove the blade set from the clipper as described earlier.
Hold the blade set in one hand, and slide the blade from side-to-side
to remove any trapped hair or debris (Diagram O).
CARE AND SERVICING OF THE BATTERY SYSTEM
Your clipper, battery pack, and charger are an integrated electrical system. Good electrical contact must be
maintained for the motor to deliver full power and lithium-ion battery to charge properly. Limited or erratic
performance caused by dirt or age can be corrected in the majority of cases.

CORRECT DISPOSAL OF THIS PRODUCT

This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take this product for environmental safe
recycling.
CAUTION: Do not hold clipper under running water to clean blades. There is danger of electrical shock and
damage to the clipper. ANDIS COMPANY is not responsible for injury or product damage that results from
this method of cleaning.
OIL
Diagram N
SLIDE
Diagram O