Transmission Velocity Configuration; Enabling The Weighing Units - Baxtran ADA Serie Manual De Instrucciones

To set the print mode, follow the procedure below:
1. Press the
2. Press the
when the display reading is stable.
3. Press the
4. Press the
5. Press the
continuous printing.
6. Press the
7. Once the setting has been made, press the
appropriate line feed parameter, then press the

TRANSMISSION VELOCITY CONFIGURATION

1. Press the
2. Press the
3. Press the
4. Press the
and confirm with the
5. Press the
6. Press the
"always test".
7. Select the desired mode and press
13. ENABLE THE WEIGHING UNITS
The weighing units can be activated or deactivated by the user:
1. Press the
2. Press the
3. Press the
deactivate unit "g" press the
4. Follow the same steps to activate or deactivate the other Oz, Ct or dwt weighing units.
key, then without releasing it press the
key and the display will show "STABLE", which indicates that the programmed print mode is Print
key to select the desired print mode and confirm by pressing
key until "InTEr" is displayed, then press the
key repeatedly to display the default interval, then press the
key to return to the weighing mode.
key
key and the display will show the message "bAud".
key and the display will show "300".
key repeatedly and the display will show the available transmission speeds. Select the desired speed
key. The display will show "ParITy" and the parity check will start.
key and the display will show "nOnE" (no check) initially.
key and the display will show the other test modes; "Odd" means "odd test" and "EvEn " means
key and the display will show "PrInT".
key repeatedly until the message "unIT" is displayed.
key and the display will show "g yes" which means that unit "g" is activated; press the
key and the display will show "g no", then press the
key: the display will show "Print"
key and the display will show "SEC".
key repeatedly to display the default line feed. (1-18) Select the
key to return to normal weighing mode.
to confirm, and the scale will return to normal weighing mode.
USER'S MANUAL ADA-APD
.
key to confirm. "0 SEC" means
key to
key to confirm.
EN EN
49