Reset To Factory Settings; Display Illumination Configuration; Weight Limit Configuration - Baxtran ADA Serie Manual De Instrucciones

14. RESTORE FACTORY SETTINGS
1. Press the
2. Press the
3. Press the
15. DISPLAY ILLUMINATION SETTING
1. Press the
2. Press the
min" which indicates that the display illumination will go off in 1 minute.
3. Press the
4. Press the

16. WEIGHT LIMIT CONFIGURATION

Configuration of the upper and lower limit values:
1. Press the
2. Press the
3. Press the
limit configuration).
4. Press the
5. Press the
repeatedly to select the decimal position.
6. Press the
key to increase the value and the
7. Enter the desired value, then press
key; to confirm the value press
8. Press the
steps as described above.
50
key and the display will show "PrinT".
key repeatedly until you can see the message "InITIA".
key to confirm; the display will show "BUSY" and the scale will return to normal weighing mode.
key and the display will show "PrinT".
key repeatedly until "bLgHT"is displayed, then press
key repeatedly to select the desired time: 1, 2, 3, 5, 10, 15, 30 or 60 minutes.
key repeatedly to select the desired time: 1, 2, 3, 5, 10, 15, 30 or 60 minutes
key.
key repeatedly until the message "InSpCT" is displayed.
key to confirm, the scale will enter the configuration mode and the display will show "SET HI" (upper
key, the display will show "50" (value initialization).
key, the display will show "SET Dp" (setting of the decimal point position). Press the
key to confirm the decimal position. The display will show the initialisation of the value. Press the
and the entered value will flash. To continue the modification, press the
and the display will show "SET HI".
key and the display will show the message
key to decrease it.
"SET LO" (setting the lower limit value); follow the same
USER'S MANUAL ADA-APD
to confirm and the display will show "1
EN EN
key