N2128Px-On Installation; Rack Mounting An N2128Px-On Switch; Installing In A Rack - Dell Networking N2128PX-ON Guía De Introducción

N2128PX-ON Installation

Rack Mounting an N2128PX-ON Switch

WARNING:
as well as the safety information for other switches that connect to or support the
switch.
The AC power connector is on the rear panel of the switch.

Installing in a Rack

WARNING:
table or desk, or attach it to a wall.
CAUTION:
Disconnect all cables from the switch before continuing. Remove all
self-adhesive pads from the underside of the switch, if they have been attached.
CAUTION:
When mounting multiple switches into a rack, mount the switches
from the bottom up.
1 Place the supplied rack-mounting bracket on one side of the switch,
ensuring that the mounting holes on the switch line up to the mounting
holes in the rack-mounting bracket. Figure 1-1 illustrates where to mount
the brackets.
Figure 1-1. Attaching the Brackets
2 Insert the supplied bolts into the rack-mounting holes and tighten with a
screwdriver.
Read the safety information in the
Do not use rack mounting kits to suspend the switch from under a
Safety and Regulatory Information
Getting Started Guide
9