Installing The Dell Readyrail System - Dell Networking N2128PX-ON Guía De Introducción

• Product should not be mounted with the rear panel facing in the
downward position.

Installing the Dell ReadyRail System

The ReadyRail rack mounting system is provided to easily configure your rack
for installation of your switch. The ReadyRail system can be installed using
the 1U tool-less method or one of three possible 1U tooled methods (two-
post flush mount, two-post center mount, or four-post threaded).
1U Tool-less Configuration (Four-post Square Hole or Unthreaded Round Hole)
1 With the ReadyRail flange ears facing outward, place one rail between the
left and right vertical posts. Align and seat the rear flange rail pegs in the
rear vertical post flange. In Figure 1-3, item 1 and its extractions illustrate
how the pegs appear in both the square and unthreaded round holes.
Figure 1-3. 1U Tool-less Configuration
2 Align and seat the front flange pegs in the holes on the front side of the
vertical post. See Figure 1-3, item 2.
3 Repeat this procedure for the second rail.
Getting Started Guide
29