Important - Harbor Breeze SARATOGA 00798 Manual Del Usuario

ASSEMBLY INSTRUCTIONS
1. Determine mounting method.
A-Downrod Mount (standard or angled ceiling)
B-Angle Mount (standard ceiling only)
IMPORTANT: If angle mounting, check to make
sure the ceiling angle is not steeper than 20˚.
2. Install mounting bracket (A) to outlet box (not included)
by sliding mounting bracket (A) over the two outlet box
screws (not included). Securely tighten two outlet box
screws.
IMPORTANT: If angle mounting, make sure open end
of mounting bracket (A) is installed facing the ceiling.
3. Remove preassembled pin and clip from downrod (E).
Save for later use.
1
2
outlet box
Outlet box
3
Clip
clip
Pin pin
6
ASSEMBLY INSTRUCTIONS
4. Insert downrod (E) through canopy (B), canopy cover (C),
and yoke cover (D). Thread wires from fan motor
assembly through downrod (E).
5. Loosen preassembled set screws from yoke on fan motor
assembly (H). Slip downrod (E) into housing yoke,
aligning holes on both parts. Insert previously removed
pin through holes on yoke and downrod (E), then insert
previously removed clip into pin until it snaps into place.
Tighten set screws.
6. Install hanger ball on top of downrod (E) into mounting
bracket (A) opening. Rotate fan until slot on hanger ball
A engages the tab on mounting bracket (A).
DANGER: Be careful when aligning tab to
slot. If not fully engaged, the fan could fall, which
could result in serious injury or death.
IMPORTANT: Do NOT use this fan with a dimmer switch
or variable speed wall control. Using a dimmer switch or
variable speed wall control will damage the fan.
E
ON
ON / OFF
switch
4
5
Set screw set screw
6
E
NO Variable NO Dimmer
speed wall switch
control
7
E
B
C
D
Clip clip
E
Pin
pin
H
Tab
tab
Slot
slot
A