Tools And Materials; Before You Begin - Kohler K-2971 Guia De Instalacion

Tools and Materials

Pipe Adjustable
Wrench Wrench
Assorted Plumbers
Screwdrivers Putty

Before You Begin

WARNING: Risk of product damage. When using this valve
in a fiberglass or acrylic installation, use the thin wall
installation kit (88526).
CAUTION: Risk of product damage. This valve contains
plastic and rubber components. Do not apply excessive heat
to the valve body when soldering.
CAUTION: Risk of product damage. Do not apply flux or
acids directly to the valve, as damage may result.
CAUTION: Risk of product damage. Do not apply
petroleum-based lubricants to the valve components, as
damage may result.
IMPORTANT! The installer is responsible for installing the valve
and adjusting the maximum water temperature of this valve
according to instructions.
Observe all local plumbing and building codes.
This valve requires a minimum operating pressure of 15 psi (103.4
kPa).
The valve shuts off by water pressure. Do not force the handle in
any direction. To turn the valve off, gently turn it to the "Off"
position.
Flush all piping thoroughly after installing the valve body.
Kohler Co.
Strap Hacksaw or Tubing Cutter
Wrench
Thread Hex
Sealant Wrench Thermometer
3
Propane
Torch
Solder
1150733-2-A