SATA AE5602T Manual Del Uso página 53

中文
AE5602T
EN DE RU KO PT JA ES
1.2 Precautions for four-wheel aligner:
A.Read carefully and keep well all the information along with the product. Comprehensively
understand use and note of the machine.
B.3D Aligner is precise instrument, which should be used by special person.
C.Computer is special for the equipment, other software or hardware are not allowed to install, All
the programs in Computer are not allowed to delete or modify.
D.Requirement for power source
1.The product apply to single phase AC220V 50HZ power source .Low- voltage or high voltage may cause instability
and even broken. it is better to use voltage stabilizer and UPS.
2.Must use three core plug and socket with ground protection to ensure personal safety and equipment stability.
3.After turn off 3D aligner, please turn off the power source to avoid harm to the equipment from the grid peak.
4.Special note: The power equipment connected the product must accord to national electrical standard, such
as no overload, circuit security etc.,. Or it will damage the product. Our company will not be responsible for the
problems.
5.Don't connect or disconnect the lines of the products when power source doesn't turn off.
E.Environment Requirement:
1.The product apply to the temperature 0 ~ 40 ℃ If temperature exceed the range, The machine may not work well.
Please take measure to keep the operating temperature.
2.Pay attention to heat radiation in operation. Don't place the computer near heat source or under sunlight:Keep
the machine around the well ventilated; do not make other objects block the cooling holes of the host, monitor
and other parts.
3.The workplace for 3D aligner should be damp-proof and anti-corrosion, Humidenvironment will have a negative
impact on the computer.
Please use a non-woven fabric to wipe or use warm neutral detergent. Once the water or other liquid poured onto
the computer, should immediately cut off the power. Clean with alcohol when wiping.
4.Dust treatment ensure equipment clean and extend the life of the machine.
5.Some parts of 3D aligner such as displays are more sensitive to the magnet, do notplace the computer and the
disk near the magnet.
F.Target plates:
1.Target plates should avoid disturbance from strong light or sunlight. Or it can not work properly.
2.Place target plates where is ventilated, dry, safe after use.
3.The surface of the plates should be regularly cleaned with a soft cloth.
4.Target plates must not be shocked,impacted or fallen to avoid the damage to sensor components.
5.Don't disassemble and change original structural parts.
6.Make sure clamps are equipped on hub firmly with rubber band as additional protection.
53