Chapter Iii Operation Procedure Of Four Wheel Aligner - SATA AE5602T Manual Del Uso

中文
AE5602T
EN DE RU KO PT JA ES
Chapter III Four Wheel Aligner Operation Procedure
3.1Preparation and limited condition before operation
Preparation includes:
(1)Check the fixed pins in turn plate and measuring sliding table in working position.
(2)Adjust the position of Turn plate according to vehicle tread, to keep wheels in the center of turn plates, which
can avoid measuring deviation.
(3)Move vehicle to lift with neutral gear and handle brake released,Stop rear wheels with rubber block to prevent
vehicle moving.
(4)Check size of hub,tire pressure and abrasion and components of steering system and suspension system, such
as tie rod ball, dampers etc.,. if unqualified found, repair it well before alignment.
(5)Extract fixed pins from turn plate and sliding table, press the front and the back of the vehicle to keep it in free
state and adjust steering wheel. And then plug the fixed pins of turn plate and sliding table.
(6)Install clamps and target plates. when installation, claws of clamps should close to rims. Each target plate
match up one wheel.
(7)Adjust the target plates
(8)Check if tools are in right place according to index pictures.
59