Side Covers; Charging The Battery - Kärcher MIC 50 Manual Del Usuario

12.7.3 Side covers

Lock for side cover
1
Side cover
2
Removing the side cover:
1 Open both locks.
2 Lift the side cover and pull it out to the side.
Attaching the side cover:
1 Insert the side cover at the side.
2 Mount the side cover at the upper edge and into the fixing slot.
3 Slide the side cover into the correct position and secure it us-
ing the locks.
12.7.4 Front cover
Lock for side cover
1
Side cover
2
Lock for front cover
3
Front cover
4
Removing the front cover:
1 Remove both side covers.
2 Open the left and right lock on the front cover.
3 Lift and remove the front cover.
Attaching the front cover:
1 Mount the front cover and fix it in place using both locks.
2 Install both side covers.
12.7.5 Radiator protective grille
Removing the radiator protective grille:
1 Lift the radiator protective grille at the top.
2 Move out the lower part
3 Remove the radiator protective grille in a downward direction.
Attaching the radiator protective grille:
1 Engage the radiator protective grille at the bottom, then snap
shut at the top.
12.7.6 Removing / installing the battery
DANGER
Danger of injury
Observe the safety regulations on the handling of batteries.
ATTENTION
Disconnect the minus terminal first when removing the battery.
Protect the battery terminals and terminal clamps with a sufficient
quantity of terminal grease.
Removing the battery
1. Remove the covering caps from the terminal clamps.
2. Release the terminal clamp (black cable) on the minus termi-
nal (-).
3. Release the terminal clamp (red cable) on the plus terminal
(+).
4. Unscrew the bracket on the battery base.
5. Take the battery out of the battery holder.
Installing the battery
1. Fit the battery into the battery holder.
2. Screw the bracket on the battery base tight.
3. Connect the terminal clamp (red cable) to the plus terminal (+).
4. Connect the terminal clamp (black cable) to the minus terminal
(-).
5. Plug the cover caps onto the terminal clamps.

12.7.7 Charging the battery

DANGER
Danger of injury
Only charge the battery with a suitable charger.
Observe and follow the instructions for use from the charger man-
ufacturer.
Observe the safety regulations on the handling of batteries.
1. Disconnect the minus terminal on the battery.
2. Connect the charger to the battery.
3. Insert the mains plug and switch on the charger.
4. Charge the battery with as small a charging current as possi-
ble.
5. After charging, disconnect the charger from the mains first and
then from the battery.
English 73