Tips And Advice On Installation - SOMFY Roll Up 28 WireFree RTS Instrucciones

EN

2. 4. TIPS AND ADVICE ON INSTALLATION

2. 4. 1. Questions about the drive?
Observations
The driven product does
not operate.
The driven product stops
too soon.
Red LED blinks slowly for
3 seconds before and after
motor running.
2. 4. 2. End limit readjustment
1
Control point must be paired to the driven product.
Β
Green LED lights on for Up limit adjusting and blinks slowly for Down limit adjusting.
Readjusting the upper end limit
1) Briefly press the UP button, to move the driven
product to the upper end limit.
2) Press and hold the UP and DOWN buttons
simultaneously until the driven product briefly
moves Up and Down.
3) Press and hold the UP or DOWN button to move the
driven product to the new desired position.
4) To confirm the new position press and hold the MY
button until the driven product briefly moves Up and
Down.
6 Copyright © 2017 - 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved
Possible causes
Drive battery is low and requires
charge.
The control point battery is low.
The control point is not compatible
or not programmed.
The thermal protection has
activated.
The end limits are incorrectly
programmed.
The driven product has exceeded
recommended weight limit.
Battery is low.
Battery is low. Battery capacity is
less than or equal to 5%.
Roll Up 28 WireFree RTS
Solutions
Charge the battery.
Check the battery and replace it as
required.
Check the compatibility and replace the
control point as required.
Wait for the drive to cool down.
Reset the end limits.
Replace driven product.
Charge the battery.
Charge the battery.
1
3
2
4