Commissioning; Tips And Recommendations For Installation - SOMFY Sonesse Ultra 50 RS485 Manual

EN

2.3. COMMISSIONING

To set the motor, use the RS485 SETTING
TOOL ref:9017142.
Connect the RS485 SETTING TOOL to the motor
switch on and follow the instruction on the RS485
SETTING TOOL (P 92).

2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION

2.4.1. Questions about the Sonesse Ultra 50 RS485?
Observations
The motorised
product does not
operate.
The motorised
product is noisy:
The motorised
product stop to soon
or to late.
54
Possible causes
The wiring is incorrect.
The motor is in thermal
protection.
An incorrect Data cable has been
used.
The drive wheel and the crown
are not suitable for the tube.
The motorised product is com-
pressed between the brackets
The tube contains swarf and
screws.
The end-limits of the motorised
product drift.
Copyright ©
Check the wiring and modify it if
necessary.
Wait until the motor cools down.
Check the Data cable
Replace the drive wheel and the crown
Increase the play between the brackets
Clean the roller tube.
Readjust the end-limits
2015 - 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
Sonesse Ultra 50 RS485
Solutions