Tips And Recommendations For Installation - SOMFY Sonesse Ultra 50 RTS Manual

EN
2.3.5. Recording the RTS control point
-- Quickly press the PROG button on the RTS control
RTS control point is programmed in the motorisation.
If the motorisation is no longer in programming mode, repeat Step 2.3.1 then perform
Step 2.3.4.
2.3.6. Adding/Deleting Somfy control points and sensors

2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION

2.4.1. Questions about the Sonesse Ultra 50 RTS?
The motorised
product does not
operate.
The motorised
The motorised
product stop to soon
or to late.
Possible causes
The wiring is incorrect.
The Motor is in thermal protection. Wait until the motor cools down.
The control point battery is weak.
The control point is not
compatible.
The control point used has not
been programmed into the motor.
The motor wheel and the crown
The motorised product is com-
pressed between the brackets
screws.
Images not contractually binding
PROG.
necessary.
Check whether the battery is weak and
Use a programmed control point or
program this control point.
Replace the motor wheel and the crown
Increase the play between the brackets
Clean the roller tube.
Readjust the end-limits
Copyright © 2014 - 2017 Somfy SAS. All rights reserved.
Solutions