Dovre 2576CBSC Instrucciones De Instalacion Y Uso página 37

adjustable damper.
An additional outlet grate can be fitted at the top of
the hearth and just below the cover plate, if
desired.
Do not use combustible material in the hearth
space, and avoid the effect of thermal bridging
when using materials that conduct heat.
Follow the instructions below when building the
hearth:
1. Lay the floor of the hearth.
Make sure the door of the appliance can swing
freely over the hearth floor.
2. Build the hearth up to the smoke dome.
Ensure that a clearance of 2 mm is maintained
between the stove and the masonry to
accommodate the thermal expansion of the
stove.
3. The inside of the hearth may, if desired, be
cladded with reflective, insulating material.
Additional cladding of the hearth space
prevents unnecessary thermal radiation
towards outer walls and/or adjacent rooms. It
also prevents damage to the hearth wall
insulation.
4. Build the rest of the hearth up to the flue gas hole
in the ceiling.
The masonry may not rest on the stove. Use a
support such as a steel beam. Leave a
clearance of at least 3 mm between the
support and the appliance.
5. Close the hearth space with the cover plate.
6. Put an air grate below the cover plate to allow
ventilation of the appliance.
7. Make an opening above the cover plate in order to
prevent any pressure build-up.
The figure below shows an example of the placing of a
stove in a hearth built in accordance with the
instructions given above.
Subject to change because of technical improvements
H
A
B
C
D
E
P
F
G
A Chimney (flue)
B Fireproof material or connector
C Cover plate
D Insulation material (minimum 5 cm)
E Fireproof wall
F Combustible wall
G Ventilation space (minimum 15 mm)
H Fireproof ceiling
I Combustible ceiling
J Convection air opening
K Insulation (optional)
L. Fireproof base
M Combustible base
N Opening to prevent pressure build-up
O Connection pipe
P Convection air to other room
Finishing
1. Put all dismantled parts back into the appliance in
their correct places.
2. Ensure that the newly built hearth is dry enough
before firing the stove.
Never light a fire in the appliance without the
fireproof inner plates.
The appliance is now ready for use.
09.20015.057
I
N
J
K
O
L M
11