Lenco DVT-1541 Manual De Operación página 13

System Connections
Connecting to an External AV Signal Source(YPbPr)
Use red, green and blue component video cables and red and white audio cables. Connect the
external AV signal source to the Y/Pb/Pr input Jacks on the rear panel of the unit and the other end
of the cables into the corresponding sockets on the TV.
After connection, turn on the power of the unit and external AV signal source and then press the
INPUT button to select COMPONENT mode.
Note: Ensure the AV signal source is also switched to component video mode.
Connecting to an External Signal Source(SCART)
Use a SCART cable (not supplied) to connect the external signal source to the SCART input jacks
on the rear panel of the unit.
After connection, turn on the power of the unit and external AV signal source and then press the
INPUT or SCART button to select SCART mode.
- 12 -