Lenco DVT-1541 Manual De Operación página 16

System Connections
Connecting to a TV Antenna
Connect TV signal input source from the aerial to the TV jack on the rear panel of the unit.
After connection, turn on the power of the unit. Then press the INPUT or TV button to select TV
mode and conduct program selection. You can follow the steps below to select channels:
However, if this is the first time the TV has been used, you must first search and store the
channels by following the steps on pages 20, 21, 22 and 23.
1. For 0~9 channel:
Press one of the number buttons to select the desired channel and wait several seconds and it
will go to the selected channel.
Or press the number buttons to select the desired channel and press the ENTER button to go to
the selected channel immediately.
Or press the number buttons to select channel 0X, and it will go to the selected channel
immediately.
2. For 10~99 channel:
Press the number buttons to select channel XX, and it will go to the selected channel
immediately.
* X is the channel number.
- 15 -