Remove The Print Ribbon - Rimage Everest III Printer Guia Del Usuario

Rimage Everest™ III and 600 User Guide

Remove the Print Ribbon

1. Open the side cover.
a. Press the two side cover latches to release the side cover.
b. Lower the side cover.
2. Access the print ribbon.
a. Open latch 1.
b. Pull the print ribbon carrier straight out of the printer.
c. Lay the print ribbon carrier on its back.
Tip: Perform cleaning procedures while the print ribbon
is removed. For more information refer to the
Everest Printer
26
Print Ribbon Carrier
section on page 30.
Clean the
Side Cover Latches
Side Cover
Latch 1
2000621_B