Kit Assembly - Metra 99-9228B Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Attach the pocket to the radio
brackets using (4) #8 x 3/8"
Phillips screws provided. (Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Attach the radio to the radio
brackets using screws supplied
with the radio. (Figure A)
4. Place the completed assembly into
the sub-dash housing, and then
secure it to the housing with (4) #8
x 3/8" Phillips screws provided.
5. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra and/or AXXESS. Re-connect the
negative battery terminal and test the
radio for proper operation.
6. Reassemble the dash in reverse
order of disassembly, and then snap
the radio trim panel over the radio.

Kit Assembly

(Figure A)
99-9228B
ISO DDIN radio provision
1. Secure the radio to the radio
brackets using screws supplied
with the radio. (Figure A)
2. Place the completed assembly into
the sub-dash housing, and then
secure it to the housing with (4) #8
x 3/8" Phillips screws provided.
3. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Re-connect the negative
battery terminal and test the radio
for proper operation.
4. Reassemble the dash in reverse
order of disassembly, and then snap
the radio trim panel over the radio.
3
(Figure A)