Answering System Setup; Voice Time /Day Stamp And - GE THOMSON 21098 Guía De Uso

NOTE: To change to "English," press the language button again.
NOTE: In remote access mode, the system follows the selected language. The
voice prompt language cannot be switched remotely.

Answering System Setup

This section shows you how to set up your answering system to receive
incoming calls. Before you begin the set up process, you must turn on the
answering system.
• Press the answer on/off button to turn the answering system on and off.
The MESSAGES indicator lights when the answering system is on. The
indicator blinks when you have messages.
NOTE: The answering system displays "- -" when it is off.
Voice Time/Day Stamp and Real Time Clock
To check the current day and time, press and release the DAY/CHECK button.
1. Make sure the answering system is ON.
2. Press and hold the DAY/CHECK button to set the day of the week.
3. Press and hold the HOUR button to set the hour (a.m. or p.m.). Example:
12AM, 1AM, or 12PM, 1PM.
4. Press and hold the MIN button to set the minute. Then press and release
the MIN button to advance in 1-minute intervals or press and hold to
increase in 5 minute intervals.
5. After the time is set, the real time clock will be displayed on the handset
within 1 minute.
NOTE: You must set the day manually. You can choose to set the time
manually as well though the time is automatically transmitted by your local
phone company as part of Caller ID service. If you subscribe to Caller ID
service, the current time is set automatically when you receive your first CID
record.
14