Emerson ASHLAND CF717BS01 El Manual Del Propietario página 20

12. Installation of Light Kit Assembly
12.6
Position the light switch pull chain through the center hole
of the glass shade.
Position the speed control switch pull chain through the
NOTE: Be sure that the fan switch chain does not
center hole of the glass shade.
make contact with the light bulbs. If necessary
reposition the light fitter to avoid the fan switch chain
from touching the light bulbs.
Place the glass shade onto the light kit assembly threaded
nipple (Figure 33).
12.7
Pass the light pull chain through the center bushing in the
bowl cap.
Pass the speed control switch pull chain through the offset
hole of the bowl cap.
Place the bowl cap on the threaded nipple and against the
glass shade (Figure 34).
Install finial nut finger tight to secure the bowl cap to the
glass shade (Figure 34).
THREADED
NIPPLE
Figure 33
GLASS
SHADE
BOWL CAP
FINIAL NUT
Figure 34
20
(Continued)
GLASS
SHADE
SPEED
CONTROL
PULL CHAIN
LIGHT SWITCH
PULL CHAIN
ETL Model No.: CF717-1