4. Installing Ceiling Cover on Fan Motor Housing
4.1
Remove and retain six screws and lockwashers from the
4.2
top of the motor housing (Figure 8A).
Remove the paper backing off the rubber gasket (supplied
in parts bag) to expose the adhesive.
Position the rubber gasket on the motor housing (small
holes in gasket centered over the screw holes in the
housing and the notched area of the rubber gasket over
the notched area of the housing).
Press the rubber gasket (adhesive side down) onto the
motor housing to secure gasket (Figure 8B).
4.3
Gently pry the decorative cap from the ceiling cover to
expose the six holes in the ceiling cover (Figure 9).
4.4
Place the ceiling cover onto the motor housing assembly
by aligning the holes in the ceiling cover with the holes in
the motor housing (Figure 10).
Secure the ceiling cover to the motor housing assembly by
reinstalling the previously removed six screws and
lockwashers (Figure 10).
(For Close-to-the-Ceiling Mounting)
REMOVE SCREWS (6)
Figure 8A
CEILING COVER HOLES (6)
CEILING COVER
DECORATIVE CAP
Figure 9
CEILING COVER
HOLES (6)
CEILING COVER
MOTOR HOUSING
ASSEMBLY HOLES (6)
Figure 10
8
INSTALL GASKET
Figure 8B
CEILING COVER
CEILING COVER HOLES (6)
CUT-AWAY
SCREWS AND
LOCKWASHERS (6)
ETL Model No.: CF717-1