6.6.2.
Operation using the
j
• If the
key is pressed during firing, it will be halted (not paused).
j
• Pressing the
key again will restart the firing from the beginning.
• The controller will look at the current kiln temperature and if this is greater than the required soak temperature then it
will automatically cool from the current temperature to the soak temperature.
• Since this process may not be desired, the
• The program can be paused, or program data can be changed while the controller is firing. This procedure is
preferable to using the
6.6.3.
Program delay
The program delay or program time delay can be used to delay the start of the firing program to a specific point in time.
⇒ The program delay can be entered or changed immediately after the start of the respective program.
⇒ Immediately after pressing the
can be set with the
Display screen
00.00
⇒ The firing process can be started by pressing the
"Program running" indicator continues to signal that a firing is in progress.
⇒ For technical reasons, there is a point between the hours and minutes in the display and not a "colon" as is usual
with times.
Note:
The program delay for the delayed start for each firing process is set to "00.00" in the factory.
6.6.4.
Program advance facility
• While firing press and hold down the
• The controller will emit a short beep and immediately advances the program by one step.
• The process is indicated accordingly in the course of the program on the graphical display by a flashing icon.
• The effect of this is as follows:
If ramping, then the controller will switch to soak at the current kiln temperature.
If soaking, then the controller will advance to the next segment if any, or else it will end the firing.
• Changes made to the operation of the controller in this way are temporary and are not stored.
6.6.5.
Program pause facility
• While firing press and hold down the
• The controller will sound a short beep and the program will pause indefinitely at the current kiln temperature.
• To release the pause, repeat the above action.
j
j
j
key.
j
key, "00.00" appears in the main display. The waiting time before the firing starts
d
f
and
keys.
Icon
Description
While the firing indicator light is flashing on the display, a program start delay of
up to "99 hours:59 minutes" can be entered using the
d
key for 3 seconds to obtain the program advance function.
f
key to obtain the pause function.
key should only be used to abort the firing process in an emergency.
j
key again or will do so automatically after 5 seconds. The
62 / 280
d
f
and
keys.