Rohdegraph; Faults; Safety Instructions - Rohde ST 410 Instrucciones De Uso

Step Description of the process
Select the wireless router in the web
12
interface and enter the access data for it.
Confirm with Save/OK and close the web
13
browser.
The controller now automatically
disconnects from the computer or
14
smartphone because a new connection to
the wireless router has been established.
8.3.

ROHDEgraph

ROHDEgraph is computer software for the visualization and archiving of firing curves from the recorded measured values of
the ST 410/ST 411 control system.
The measured values can be transferred to a computer using a USB flash drive or Wi-Fi (see Sections 8.1. and 8.2.).
Information, functions and software downloads from the Internet at:
www.ROHDE.eu
⇒ On the ROHDE website, under Service in the "Arts and Crafts" section!
9.

Faults

9.1.

Safety instructions

DANGER
Disconnect the control unit and kiln from the power supply before troubleshooting and repair work.
⇒ Risk of severe personal injury, property damage and even death.
NOTE
In the event of faults that you cannot rectify yourself, contact a qualified electrician, the local
specialist or the manufacturer.
NOTE
In the event of faults which have to do with the kiln itself to which the control system is connected,
the instruction manual for the kiln must be followed.
Remark
You should find the access data in the documents attached to
the wireless router.
A successful connection to the wireless router is displayed.
The controller now permanently sets up the wireless network
with the router.
⇒
If this was not successful, repeat the steps, starting with
step 1, try the connecting as described in Section 8.2.3.
72 / 280