Description Of The Appliance; Before Startup; Water Supply; Operation - Kärcher K 3.200 Manual Del Usuario

Operation

Description of the Appliance

These operating instructions describe the
maximum equipment. Depending on the
model, there are differences in the scopes
of delivery (see packaging).
Illustrations on Page 2
1 Water connection with integrated sieve
2 Coupling element for water connection
3 Hose coupling
4 Detergent suction hose (with sieve)
5 Trigger gun
6 Lock trigger gun
7 Key to detach the high pressure hose
from the trigger gun
8 High pressure hose
9 Storage for accessories
10 Transport handle, detachable
11 Quick coupling for high pressure hose
12 Appliance switch "0/OFF"/ „I/ON"
13 Mains cable with mains plug
14 Carrying handle
15 Wheels
16 Spray lance with pressure regulation
(Vario Power)
17 Spray lance with Dirtblaster
Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.

Before Startup

Illustrations on Page 3
Illustration
 Push the wheels into the intake and se-
cure with the enclosed plugs, watch for
positioning of plug.
Illustration
 Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
 Check the secure connection by pulling
on the high pressure hose.

Water supply

ATTENTION
Impurities in the water can damage the
high-pressure pump and the accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
For connection values, see type plate/tech-
nical data.
Observe regulations of water supplier.
Water supply from mains
WARNING
According to applicable regulations, the ap-
pliance must never be used on the drinking
water net without a system separator. A
suitable system separator by KÄRCHER or
alternatively a system separator according
to EN 12729 type BA must be used.
Water that has flown through a system sep-
arator is no longer classified as drinking
water.
ATTENTION
Always connect the system separator to
the water supply, never directly to the appli-
ance!
 Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Illustration
 Screw the coupling element to the wa-
ter connection on the appliance.
Drawing in water from open reservoirs
This high-pressure cleaner is suited to work
with the KÄRCHER suction hose with back-
flow valve (Optional accessory, order no.
4.440-238) to draw in surface water, e.g.
from water butts or ponds (see specifica-
tions for max. suction height).
 Fill the suction hose with water.
 Screw the suction hose into the water
connection of the appliance and insert it
into the water source (e.g. rainwater
drum).
 Separate the high pressure hose from
the high pressure connection of the ap-
pliance.
English 7