Grinder Assembly - Weston 16-0201-W Manual Del Usuario

1. Insert the Auger Bearing end of the
Auger into the Grinder Body through the
hole in the front of the Grinder (figure 1).
Rotate the Auger while inserting to fully seat
the Auger into the Grinder Body.
2. Slide the Knife onto the end of the Auger
Pin on the front of the Auger making sure
the cutting edges of the Knife are facing
outward (figure 2).
3. Slide the Grinding Plate of choice onto
the end of the Auger Pin. Align the tabs on
the Grinding Plate with the plate notches
in the Grinder Body so that the Grinding
Plate fully sits in the opening of the Grinder
Body (figure 2).
4. Snugly screw on the Front Ring Nut. DO
NOT OVER TIGHTEN! (If the Front Ring
Nut is screwed onto the Grinder Body too
tightly, the Auger will be hard to turn/will not
turn. The Front Ring Nut should be snug,
allowing the Auger to spin with ease.)
5. Slide the Handle into the back of the
Grinder Body (figure 3).
6. Insert the Stomper into the Chute of the
Grinder Body (figure 4).
7. Dampen the rubber Suction Cup on
the Base of the Grinder and press it onto
a smooth, level working surface. NOTE:
When positioning, make sure the Suction
Cup Locking Arm is in the raised position.
8. Hold the Base and push the Suction
Cup Locking Arm to the down position.
9. To release the Suction Cup, move the
Suction Cup Locking Arm to the upward
position.

GRINDER ASSEMBLY

-4-
Auger
Bearing
(Front)
Grinder
Body
Auger
Knife
Tabs
Handle
Stomper
Suction Cup
Locking Arm
Figure 1
Auger
Pin
Plate
Nothches
Auger
Figure 2
Grinding
Plate
Front
Ring Nut
Figure 3
(Backside)
Grinder
Body
Figure 4
Chute