Installation; General Preparation - Dovre Vintage 50-35-30 Instrucciones De Instalacion Y Uso

Installation

General preparation

Please check the appliance for damage caused
during transport or any other damage or defects
immediately after delivery. The appliance is
attached to the pallet with screws at the bottom.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire grate, top plate, ashtray) from the
appliance before you start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on. The appliance
is attached to the pallet with screws at the
bottom.
1. Open the door; see the following figure.
Subject to change because of technical improvements
Installation
2. Remove the fire-resistant inner plates; see the
following figure.
The following tips may help in the removal of the
inner plates:
a. Lift baffle plate 3 on the front and pull it
forwards by 2 cm.
b. Now, lift the baffle plate on the left-hand side
and remove the left-hand inner plate 1 first.
c. Then remove baffle plate 3 followed by inner
plates 7, 8, 9, 2 etc.
Vermiculite inner plates are light and tend
to be ochrous in colour when delivered.
They insulate the combustion chamber to
boost combustion. Cast iron inner plates
protect the combustion chamber and
dissipate heat to the environment.
7