Changing The Decode Mode - JVC TH-V70 Manual De Instrucciones

Basic operations

Changing the decode mode

When you play a disc (or software) encoded with Dolby Digital or DTS Digital Surround, the following symptoms may occur:
• Sound does not come out at the beginning of playback.
• Noise comes out while searching for or skipping chapters or tracks.
In these cases, change the decode mode to "DOLBY D" (for Dolby Digital) or "DTS" (for DTS Digital Surround).
From the remote control ONLY:
Press DECODE to select the decode mode when DVD or AUX DIGITAL is selected as the source.
The current decode mode appears on the display window.
Example: When "AUTO/PCM" is selected.
L C R
LFE
LS RS
SURROUND
DIGITAL
Each time you press the button, the decode mode changes as follows.
] AUTO/PCM ] DOLBY D ] DTS ] (back to the beginning)
• AUTO/PCM: Normally, select this.
This system automatically detects the incoming signals.
• DOLBY D: Select this if the cases above occur when playing a disc (or software) encoded with Dolby Digital.
• DTS: Select this if the cases above occur when playing a disc (or software) encoded with DTS Digital Surround.
NOTES:
• When "DOLBY D" or "DTS" is selected, if the signal encoded with another digital format comes in, you cannot listen to the sound. (
or indicator flashes.)
• Changing the source returns the decode mode to "AUTO/PCM" automatically.
25
TV AUDIO
AUX FM/AM DVD VCR 1 VCR
DECODE
AUDIO ANGLE SUBTITLE
RETURN DIGEST ZOOM VFP
+
PROGRESSIVE
TOP MENU MENU ZOOM
–
SOUND
– +
CONTROL SUBWOOFER EFFECT
1 2 3
VCR
– +
CENTER TEST
5 6
4
TV
– +
SLEEP
REAR-L
7 8 9
– +
SETTING REAR-R
0 +10
10
TV RETURN FM MODE
100+
ON
SCREEN
AUDIO/
TV/VCR
CATV/DBS
ENTER
SURROUND
CHOICE
MODE
TV VOL CHANNEL VOLUME
TV/VIDEO MUTING
1 ¡
/REW
PLAY FF/
DOWN TUNING UP
STOP PAUSE
REC
MEMORY STROBE
DIMMER
DECODE button
PROGRESSIVE (VFP) button
DIGITAL