Baby Jogger City Go Manual Del Usuario página 21

BASE INSTALLATION - LAP/SHOULDER BELT
1
2
3
4
CLICK
Before installing base, make sure vehicle is on
level ground. Place base on an approved vehicle
seat location.
1 Ensure the vehicle seat belt is not twisted
and route the vehicle belt through the first belt
path opening then under the belt lock-off and
down through the second belt guide.
2 Buckle the vehicle seat belt.
3 While pressing the base down into the seat,
pull on the vehicle belt to tighten.
4 Close the lock-off over the lap belt until it
clicks into place.
No te: Check to make sure base is secure by
moving the it from front-to-back or side-to-
side at the vehicle belt path. The vehicle belt
should not loosen and the base should not
move more than 1 inch from side to side or front
to back.
21