Baby Jogger City Go Manual Del Usuario página 22

BASE INSTALLATION - LAP BELT
1
2
3
4
CLICK
Before installing base, make sure vehicle
is on level ground. Place base on an
approved vehicle seat location.
1 Ensure the vehicle seat belt is not
twisted and route the vehicle belt
through the first belt path opening
then under the belt lock-off and down
through the second belt guide.
2 Buckle the vehicle seat belt.
3 While pressing the base down into the
seat, pull on the vehicle belt to tighten.
4 Close the lock-off over the lap belt until
it clicks into place.
No te: Check to make sure base is secure
by moving the it from front-to-back or
side-to-side at the vehicle belt path. The
vehicle belt should not loosen and the
base should not move more than 1 inch
from side to side or front to back.
22