Attaching The Car Seat - Baby Jogger City Go Manual Del Usuario

ATTACHING THE CAR SEAT

1
2
3
No te: Check to make sure green is visible on
the indicators before installing the carrier
onto the base. If green is not visible, pull
up on the red release handle.
1 Check the level indicator to make sure
it is level. If it is not level, remove seat
from base and adjust the foot on the
base (see Adjusting the Recline) then
reinstall base. Check that the ball rests
in the zone of your child' s weight.
2 Attach the carrier into the base until
you hear a click. Lift up on the handle
of the carrier to make sure that it is
securely attached in the base.
3 To remove the seat from the base, pull
up the red release handle located on
the base. Lift carrier up.
23