# 037
Cause
Documents could not be received because there was insufficient memory available.
Remedy
Erase unwanted documents and documents with errors from memory to increase the amount
of available memory. (See Chapter 2, "Introduction to the Mail Box Functions," in the Copying
and Mail Box Guide, and Chapter 6, "Receiving Documents," in the Sending and Facsimile
Guide.)
#099
Cause
Copying/printing was interrupted.
Remedy
Try copying/printing again.
# 701
Cause 1
The specified Department ID does not exist, or the password has changed.
Remedy
Enter the correct Department ID or password using
panel, and try again.
Cause 2
The Department ID or password was changed while the machine was processing a job.
Remedy
Change the Department ID and password, and try again. If you do not know the password,
contact your System Manager.
Cause 3
<Allow Printer Jobs with Unknown IDs> is set to 'Off'.
Remedy
Set <Allow Printer Jobs with Unknown IDs> to 'On'. (See "Accepting Print and Scan Jobs
with Unknown IDs," in the Reference Guide.)
# 703
Cause
The hard disk is full, and no more images can be scanned.
Remedy 1
Wait a few moments, and try scanning again after other send jobs are complete.
Remedy 2
Erase documents stored in inboxes. If the machine still does not operate normally, turn the
main power OFF, and then back ON again. (See "Main Power and Control Panel Power," in
the Reference Guide.)
# 711
Cause
The inbox memory is full.
Remedy
Erase unnecessary documents stored in the inbox. (See Chapter 2,"Introduction to the Mail
Box Functions," in the Copying and Mail Box Guide.)
# 712
Cause
The maximum number of documents are already stored in the inbox.
Remedy
Erase unnecessary documents stored in the inbox. (See Chapter 2,"Introduction to the Mail
Box Functions," in the Copying and Mail Box Guide.)
-
(numeric keys) on the control
List of Error Messages
3
3-7