Regulation With Remote Control; Warning Signals - Sol Welding CRONOS Serie Manual De Instrucciones

Instruction Manual
8.5

REGULATION WITH REMOTE CONTROL

The welding current can be regulated from a distance in the TIG
mode using the MANUAL or FOOT remote control.
1. Connect the 7-pin Plug of the remote
control to the Receptacle (10).
The display will blink for a few seconds.
2. Set the welding current using the remo-
te control.
NOTE: the welding current is regulated
from the minimum current of the machine
to the set current on the display.
Ex. If the I2 set current is 200A, the regu-
lation will be from 5A to 200A.
9.
10

WARNING SIGNALS

. SEGNALI DI ALLARME
NOTE: numbers shown below are referring to Fig. 1 chapter 6
COMMANDS DESCRIPTION to Page 4.
OVERHEATING Protection
NOTE: in case the ANTISTICKING protection turns ON, so will the
yellow LED (4). See page 5.
CRONOS SERIES
1. This protection is trig-
gered off if the internal tem-
perature of the generator
exceeds the pre-fixed va-
lues. In this occurs, the cur-
rent is cut off.
This protection is automati-
cally removed when the
temperature returns to the
normal limit. When ON, this
protection will be signaled
by the yellow LED (4).
GB
9
GB